What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 17.06.2025 09:54

nine
The MOV will conduct when the voltage exceeds 50% of line voltage.
At one ohm, the resistor has a maximum of 1 watt power.
so, what happens?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
The third is lightning and “how it gets conducted into a home.”
Why do narcissists keep calling on the phone after years of separation?
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Here is a simplified AC power diagram.
Barnstars:
[old diagram got deleted by accident]
eight
but this device (an Inductor) … impedes the rapid changes in the current.
Why do men choose to marry a plain Jane woman over a pretty woman?
One
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Older Americans are happiest living in these 5 US states, study says — is yours one of them? - Yahoo
One is “what exactly is in a ‘surge protector’ ? ”
But… the neutral is now “floating” because of the 1 ohm resistance.
Upvotes:
Why is social media so anti-fee speech, and have they become total BS?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Can the fuse protect the electronic devices from lightning instead of a surge protector.
How do you feel about the impending end of what Donald Trump calls "the Green New scam"?
A fuse is a non-resetable over current circuit protector.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
So, the voltage could go up to 500 volts, and the fuse will not open up.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
the problem then depends on "how fast does the fuse operate?".
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–16 [ OO OLAOYE OYEBODE ]
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
but I think this circuit , shows a few more pieces.
What is the most memorable thing that happened in your college days?
Now when you have a certain ac resistance, then a current flows in a loop.
It also is a device that limits the change in current flow.
He then describes Rainy Season and Lightning.
What is the meaning of "ero" in Japanese?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Former Packers WR makes long touchdown in UFL championship - Acme Packing Company
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
[image of Common-mode choke]
These are simplified answers to the original question, and does not change anything I wrote above.
There are two important concepts here.
This is where the MOV conducts again, and dissipated the energy.
For this case there are devices called Metal oxide varistors (MOV).
The other is “what does a “fuse” do?”
At least they know the answer if they wanted it.
Edit 2024–10.
These devices are installed between the “hot” and “neutral” and protective ground.
What is lightning?
An AC voltage/ current source, and an ac inductive load.
He then asserts :
2024–10–10[John johnson John Johnson ]
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Because the load is inductive, the current lags the voltage.(by a bit).
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
A circuit breaker is similar, but is resettable.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
First Sentence:
This is where this question deviates from being a 'generic' question, and becomes more specific.
The bolt then partially travels down the line to your home.
What does a fuse do?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
(Dc diagram shown, AC is similar).
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This one hit behind the barn.
It seems Mohan does not understand the difference between a comment and an Answer.
But it can get overloaded, and no longer works.
This device then solves the entire problem.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
There are three different concepts here that are getting confused.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
what exactly is a ‘surge’ protector?
This is 'the assistant's answer'
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
I post the exact comment here.
In schematic diagrams this is the symbol for a fuse:
He then describes the function of a fuse.
a photo is worth a thousand words.